|
|
| Intact. Head of triglyph battered; top surface chipped around cuttings for T-clamps. Doric frieze block, consisting of triglyph, backer, and backer for adjacent metopes. Cuttings for T-clamps on each joining ... 23 July 1981 ... Head of triglyph battered; top surface chipped around cuttings for T-clamps. Doric frieze block, consisting of triglyph, backer, and backer for adjacent metopes. ... On top surface, setting line for geison 0.208m. from left edge, with pry hole for geison 0.245m. from left edge. |
| Block apparently complete. Only the right end has been exposed; in its upper half the end was left rough and its front edge chamfered to take the overlapping next frieze block (?); the lower half is cut ... 18 July 1963 |
| Block now rests upside down so its original top is not visible. Both ends of block treated like right end of A 3386, i.e. rough in upper half and chamfered at front, square cut in lower half. Back of block ... 18 July 1963 ... In the very middle of the top is a large dowel hole for fastening the geison (an end dowel that gripped two adjacent blocks) and a cutting for a clamp leading to the frieze backer. For sketch cf. notebook ΒΒ VII, p. 1358; for a photo cf. notebook Τ XXXIV, p. 6687.
6 February 1967: Original location in Square Peristyle: Second from interior angle triglyph block. (W.B.D. |
|
|
