|
|
Two-thirds of bowl restored.
Conical stand with ridge and torus molding at base. Shallow, flaring bowl. Hard pink fabric (7.5YR 7/4); traces of white paint.
Another from same context: P 5823 ... 250-200 ... Conical stand with ridge and torus molding at base. |
Male bust (head broken off) and circular pedestal, with collared rim on top, torus molding at bottom.
Presence of pellets inside hollow bust suggest use as rattle.
Buff surfacing, worn.
Soft red clay ... 1956 ... Male bust (head broken off) and circular pedestal, with collared rim on top, torus molding at bottom.
|
Lower part of neck, broken above and below.
At bottom, where neck joined body, torus molding with scraped groove above. At top, two torus moldings, both with scraped groove above and below. Grooves shallow ... 2nd century? ... At bottom, where neck joined body, torus molding with scraped groove above. At top, two torus moldings, both with scraped groove above and below. |
| Upper torus of base chipped; about half of plinth preserved. Ionic base with rectangular plinth. Base molding: torus, scotia, torus.
Pentelic marble. Catalogued in May 1971.
Found at O/10-15/17 (Fall ... 1954 ... Upper torus of base chipped; about half of plinth preserved. Ionic base with rectangular plinth. Base molding: torus, scotia, torus.
|
| Single fragment.
Spreading ring foot with flat resting surface and torus molding at outer face of foot. Part of exterior wall preserved at top of foot, part of interior bottom of vessel preserved.
Reserved: ... 9-10 March 1933 ... Spreading ring foot with flat resting surface and torus molding at outer face of foot. |
Three-fourths of rim, half of lower body, and upper molding at base of knob restored; top of knob missing. Knob and lid do not join.
Horizontal outer zone, with scraped groove at outer edge, separated ... 200-150? ... Three-fourths of rim, half of lower body, and upper molding at base of knob restored; top of knob missing. ... Horizontal outer zone, with scraped groove at outer edge, separated from rising center by molding between two scraped grooves. Torus molding at top, below knob. |
Part of top side of lid with torus molding grooved on top, and wall. Glaze fired red on underside and on wall on inside near top. P.H. 0.06; max. dim. 0.08.
On top side of lid, woman's head (top) to right ... Probably late 5th century B.C ... Part of top side of lid with torus molding grooved on top, and wall. |
Fragment of an unfluted column with a simple torus molding at the bottom. Part of dowel hole at center of bottom preserved. Broken above and at both sides, but nearly the full diameter of the shaft is ... 14 April 1951 ... Fragment of an unfluted column with a simple torus molding at the bottom. |
| Ring rosette. Ring. Support. Swastika. Rosettes, frieze of. Rosette. Thymiateria. Rosette as filling ornament. Tongue pattern. S-shaped filling ornament. St. Andrew's cross. Scale pattern. Shapes not found ... Agora 23 370 ... Torus molding |
| A small fragment of the torus missing; minor chips; otherwise intact.
The base consists of a lower member, on which rests a torus, cut from the same block. The middle section of the torus is worked horizontally ... 11 August 1949 ... A small fragment of the torus missing; minor chips; otherwise intact.
The base consists of a lower member, on which rests a torus, cut from the same block. ... At top of torus a shallow concave molding with traces of green paint. |
| Found in many pieces; in part put together, most of the top missing.
Battered molding at bottom: torus with guilloche (?); cyma with leaf; bead and real. In the plain flat top an egg-shaped sinking.
Relief ... 9 April 1936 ... Battered molding at bottom: torus with guilloche (?) |
|
|
.png.icon.jpg){kind=icon}
