|
|
Hemispherical Cup.
P 31754 a, b
Two nonjoining sections of rim.
Steep wall. Band of rouletting at top, bounded by two grooves at bottom and one at top. Straight rim. Very hard fabric, possibly overfired, ... Context of ca. 250-165 |
| The end of the spout, fragments of the wall and about two-thirds of the rim missing; restored in plaster.
Squat pear-shaped jug on ridged flaring ring foot; narrow neck; broad round mouth with down-turned ... 12 May 1939 |
Back, with handle if any, broken off.
Flat rim with a shallow groove around it. Pierced lug at left side. Base set off by a groove; rising in center.
Unglazed. Like blister ware fabric.
Gritty gray with ... 10 February 1937 |
Tip of nozzle, handle, side knob missing.
Concave bottom, marked off by a groove; shallow nearly straight sides, broad flat rim with groove at outer edge. Vertical strap handle, pierced side knob. Long ... 6 June 1938 |
The nozzle and very little of the adjoining body preserved.
Groove around rim. The nozzle shows traces of smoothing with a flat implement.
Red clay with pinkish-gray surface.
Type IX (Blister Ware) of ... 22 May-6 June 1935 |
| The fragment includes parts of the upper walls, the flaring rim, and one twisted horizontal handle. The lip is bent over and grooved outside. A large bowl, with moulded decoration of Erotes with garlands ... 2 March 1933 |
The nozzle and the vertical ring handle missing.
Reels to each side of rim, and volutes at base of nozzle; spools on rim to each side of handle; one preserved, pierced to carry wick-pin.
Plain rim with ... July 1946 |
Intact.
Watch-shaped body; bottom slightly concave; unpierced lug at side; groove around filling hole; rather long nozzle.
Blister Ware.
Rather roughly made.
Gray clay on surfaces, shows red in chips ... 20 May 1947 |
The lamp part broken away around the bottom.
Through the middle a long vertical shaft, pierced near the top. Around the shaft above and below the hole, grooves. The start of the nozzle can be seen on ... 22 May 1935 |
Intact.
Concave base, pierced knob, no handle.
Low rounded body with groove around filling hole. Nozzle flattened on top.
Imitation blister ware fabric (?).
Buff clay with light gray wash; pared surfaces ... 6 June 1938 |
Intact.
Similar to L 3524 (Ω 816), but the walls higher and straighter, and the groove at the outer edge of rim, not around filling hole.
Thin gray wash.
Buff clay.
Type IX (blister ware) of Corinth collection, ... 6 June 1938 |
| Fragment preserving part of nozzle and most of one side of lamp; rim and wall profile complete, but center of floor lacking.
Sharply convex wall; bottom apparently plain and flat: no base.
At the inner ... May-June 1951 |
Most of the body preserved; the handle, the end of the nozzle, part of the floor and a piece of the side missing.
Vertical band handle; flat bottom; broad open nozzle; shallow angular body; the edge of ... 27 June-5 July 1947 |
Chip from left side missing, may have held a lug.
Flat bottom; watch shaped body with plain rim; groove around filling hole; long nozzle; unpierced lug on right side; no handle.
Blister ware.
Handmade ... 25 May 1946 |
|
|
